MAN #650387
Setup Menu
-Id 61,62,F1,F2 set the J1850 device ID.
CYL 4,6,8 set the engine cylinder count
CAL 3.0 – 20.0 set the speedometer calibration
ADJ fine adjustment of the speedometer calibration
Cod display the revision code
Rst no,YES reset all settings to factory default values.
Tachometer Setup
• Hold the switch beside the STA-1000 terminal strip while turning the key on. The display will show “888” while
this is held.
• Release the switch. The display will show “-ID”.
• Press and release the switch until “CYL” is shown.
• Press and hold the switch until “ -ñ” is shown.
• Release the switch. The current engine cylinder setting will be shown: 4, 6, or 8. The tachometer output will
also be generating a 2000 rpm signal to verify the reading on your gauge.
• Press and release the switch to change the setting.
• Press and hold the switch until “ -ñ” is shown to save the setting.
• Release the switch.
• Turn the key off to exit.
Speedometer Setup
There are two methods of setting or calibrating the speedometer. The first is “CAL” and this allows you to select a
signal from 3,000 – 20,000 pulse per mile calibration in steps of 1,000. The second is “ADJ” and this allows the signal
to be finely adjusted up or down.
“CAL” Setup
• Hold the switch beside the STA-1000 terminal strip while turning the key on. The display will show “888” while
this is held.
• Release the switch. The display will show “-ID”.
• Press and release the switch until “CAL” is shown.
• Press and hold the switch until “ -ñ” is shown.
• Release the switch. The current speedometer calibration setting will be shown. The speedometer output will
also be generating 60 mph (96 km/h) signal to verify the reading on your gauge.
• Press and release the switch to change the setting from 3.0 – 20.0 (3,000 – 20,000 ppm).
• Press and hold the switch until “ -ñ” is shown to save the setting.
• Release the switch.
• Turn the key off to exit.
“AdJ” Setup
• Hold the switch beside the STA-1000 terminal strip while turning the key on. The display will show “888” while
this is held.
• Release the switch. The display will show “-ID”.
• Press and release the switch until “AdJ” is shown.
• Press and hold the switch until “ -ñ” is shown.
• Release the switch. “ADJ” will be shown and the speedometer output will also be generating 60 mph (96
km/h) signal to verify the reading on your gauge.
• Press and hold the switch to change the speedometer signal. It will alternate between increasing the signal
and decreasing the signal each time you press the switch.
• After four seconds of not pressing the switch, it will save and exit the adjust setting.
• The display show “CoD”.
• Turn the key off to exit.
(75 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale